Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Front End Sheet Metal Cross Brace Bracket (2) - Install

CAUTION:

Front End Sheet Metal Cross Panel Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel (2) - Install
Air Inlet Grille Panel Retainer (1) - Install [4x]
Install the windshield washer hose.
Courtesy of GENERAL MOTORS COMPANY

Clean the windshield wiper transmission pivot shaft splines with a soft wire brush before installing the windshield wiper arms (3).
Position the windshield wiper arms (3) on the windshield wiper transmission pivot shafts.
Windshield Wiper Arm Nut (2) - Install and tighten [3x] - Fastener Specifications
Windshield Wiper Arm Finish Cap (1) - Install [3x]
Courtesy of GENERAL MOTORS COMPANY

Front Fender Ornamentation Vent (1) - Install
Front Fender Ornamentation Vent Bolt (2) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Trim Finish Compartment (2) - Install - Front Trim Finish Compartment Replacement
Courtesy of GENERAL MOTORS COMPANY

If required, realign the windshield wipers to their respective alignment circles (1) on the windshield.
Lubricate the windshield with clean washer fluid.
Run the windshield wipers for two complete cycles then turn off the windshield wipers.
Ensure the windshield wipers are in the full park position.