Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Valve Rocker Arm Oil Control Valve - Bank 1 - Remove - Valve Rocker Arm Oil Control Valve Replacement - Bank 1
1	Camshaft Position Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Sensor WARNING: Refer to Safety Glasses Warning . Procedure Use compressed air to remove debris from the Camshaft Position Sensor and surrounding cavities prior to removing the camshaft position sensor. Disconnect the electrical connector.
3	Camshaft Position Sensor Seal NOTE: Always install the camshaft position sensor O-ring supplied with the NEW camshaft position sensor. If reinstalling the sensor, inspect the camshaft position sensor O-ring and replace as necessary. Lubricate the camshaft position sensor O-ring with clean engine oil prior to installing the camshaft position sensor.