Removal Procedure

WARNING: This page is about a different car, the 2020 GMC Terrain and 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Bumper Fascia Removal And Installation Location (Terrain)
Courtesy of GENERAL MOTORS COMPANY

Release the front 5 front wheelhouse opening molding retainers (1) and reposition.
Courtesy of GENERAL MOTORS COMPANY

Underbody Front Air Deflector(1) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Remove the 4 left side front wheelhouse bolts (1) and reposition the wheelhouse panel.
Remove the 3 left side front tire front air deflector bolts (2) and reposition.
Courtesy of GENERAL MOTORS COMPANY

Remove the 4 right side front wheelhouse bolts (1) and reposition the wheelhouse panel.
Remove the 3 right side front tire front air deflector bolts (2) and reposition.
Courtesy of GENERAL MOTORS COMPANY

Hood Secondary Latch Release Cable(2) - Remove - Hood Secondary Latch Release Cable Replacement
Courtesy of GENERAL MOTORS COMPANY

Front Grille Bolt(1) - Remove[6x]
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Bolt(1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Carefully push a small nylon wedge between the fascia (1) and the fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia.
Courtesy of GENERAL MOTORS COMPANY

With the aid of an assistant, remove the fascia.(1)
Disconnect all electrical connectors.