LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 1.5L (LYX)) >> Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM3689044Courtesy of GENERAL MOTORS COMPANY

    Crankshaft Balancer(1)@Crankshaft(3) - Install

  2. Make sure that the key is properly seated (4) on crankshaft balancer notch.
  3. Install the EN-51368  installer (2)
  4. Install the crankshaft balancer by tightening the EN-51368  installer (2).
  5. Remove the EN-51368  installer (2)
  6. GM3686986Courtesy of GENERAL MOTORS COMPANY

    Install and hand tighten the crankshaft balancer bolt (4).

  7. Install the EN-44226-1  remover (2) to the crankshaft balancer (1).
  8. Crankshaft Balancer Bolt(4) - Tighten - Crankshaft Balancer Installation 
  9. Remove EN-44226-1  remover (2) from the crankshaft balancer (1).
  10. Drive Belt Replacement  - Install
scientia non olet · About LEMON Manuals