LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 1.5L (LYX)) >> Repair Instructions >> Crankshaft Balancer Installation

Crankshaft Balancer Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Crankshaft Balancer Bolts Tightening Sequence
GM3600370Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Install the EN-51760  holder, lock the automatic transmission flex plate via the starter ring gear.
Special Tools 
EN-51760  Flywheel Holder
For equivalent regional tools, refer to Special Tools .
1 Crankshaft Balancer
Procedure 
Using the screw, washer, bearing, and nut from the EN-51368  installer, seat the crankshaft balancer.
Special Tools 
EN-51368  Front Crankshaft Seal Installer
For equivalent regional tools, refer to Special Tools .
2 Crankshaft Balancer Bolt
CAUTION:

Refer to Fastener Caution .

CAUTION:

Refer to Torque-to-Yield Fastener Caution .


Procedure 
Tighten the NEW crankshaft balancer bolt in the sequence shown.
  1. Tighten the bolt a first pass to 100 N.m (74 lb ft).
  2. Loosen the bolt 360 degrees.
  3. Tighten the bolt a second pass to 100 N.m (74 lb ft).
  4. Tighten the bolt a final pass 180 degrees using EN-45059  angle meter.
  5. Remove EN-51760  holder once final torque is achieved.

Special Tools 
EN-45059  Angle Meter
For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals