|
Preliminary Procedures
- Remove the instrument panel lower trim panel. Refer to Instrument Panel Lower Trim Panel Replacement
- Remove the instrument panel center air outlet duct. Refer to Instrument Panel Center Air Outlet Duct Replacement
.
- Remove the windshield defroster outlet duct. Refer to Windshield Defroster Outlet Duct Replacement
.
- Remove both of the instrument panel upper trim panel brackets:
- Remove the steering column. Refer to Steering Column Replacement
.
- Remove the body control module bracket. Refer to Body Control Module Bracket Replacement
.
- Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement
.
|
| 1 |
Instrument Panel Tie Bar Brace Nut
Tighten
22 N.m (16 lb ft) |
| 2 |
Radio Speaker Amplifier Bolt
Tighten
9 N.m (80 lb in) |
| 3 |
Heater Bolt (Qty: 6)
Tighten
9 N.m (80 lb in) |
| 4 |
Instrument Panel Tie Bar Brace Bolt (Qty: 2)
Tighten
22 N.m (16 lb ft) |
| 5 |
Instrument Panel Bolt (Qty: 4)
Tighten
22 N.m (16 lb ft) |
| 6 |
Instrument Panel Tie Bar Procedure
- Disconnect the electrical connectors.
- Note the location and routing of the instrument panel wiring harness in order to ensure proper installation.
- Support the HVAC module in order to prevent damage.
- With the aid of an assistant remove the instrument panel tie bar assembly from the vehicle.
|