LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T40 (MNH MNK) Or 6T45 (MHG) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Range Selector Actuator
    GM4323068Courtesy of GENERAL MOTORS COMPANY
  1. Position the range selector actuator (2) to the transmission.
  2. Install the three range selector actuator retaining fasteners (1) and tighten to 22 N.m (16 lb ft).
  3. Connect the range selector actuator lever link.
  4. Connect the electrical connector.
  5. Connect the three starter cable retainers to the range selector actuator.
  6. Reposition the radiator surge tank to the vehicle. Radiator Surge Tank Replacement (LYX without KL9)Radiator Surge Tank Replacement (LTG LYX with KL9)Radiator Surge Tank Replacement (LH7 FWD)Radiator Surge Tank Replacement (LH7 AWD)
  7. Fig 2: Auxiliary Water Pump Bracket Nut And Auxiliary Water Pump
    GM4734617Courtesy of GENERAL MOTORS COMPANY
  8. Install the heater inlet and outlet pipe bracket nut and tighten to 22 N.m (16 lb ft).
  9. Fig 3: Brake Master Cylinder Assembly
    GM3903270Courtesy of GENERAL MOTORS COMPANY
  10. Install the brake master cylinder (1). Brake Master Cylinder Replacement
  11. Install the primary brake pressure modulator valve pipe. Brake Pressure Modulator Valve Pipe Replacement (Primary)Brake Pressure Modulator Valve Pipe Replacement (Secondary)
  12. Install the secondary brake pressure modulator valve pipe. Brake Pressure Modulator Valve Pipe Replacement (Primary)Brake Pressure Modulator Valve Pipe Replacement (Secondary)
  13. Adjust the range selector lever link. Range Selector Lever Link Adjustment 
  14. Install the charge air cooler outlet air tube. Charge Air Cooler Outlet Air Tube Replacement
  15. After installation is complete, perform the transmission adaptive values learn procedure. Transmission Adaptive Values Learn