LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T40 (MNH MNK) Or 6T45 (MHG) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Link Adjustment

Range Selector Lever Link Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine control module bracket. Engine Control Module Bracket Replacement
    2. Fig 1: Adjuster Bolt, Linkage End Fitting And Transmission Lever Ball Stud
    GM4445724Courtesy of GENERAL MOTORS COMPANY
  2. Loosen the adjuster bolt (1).
  3. Remove the linkage end fitting (2) from the transmission lever ball stud (3).
  4. Ensure the linkage end fitting (2) can freely slide on rod (4).
  5. Reinstall the end fitting (2) over the transmission lever ball stud (3).
    6. CAUTION:

    Fastener Caution

  6. Tighten the adjuster bolt (1) to 4.7 N.m (42 lb in).
  7. Install the engine control module bracket. Engine Control Module Bracket Replacement
  8. Perform the transmission range control module range motor position learn procedure, Transmission Range Control Module Range Motor Position Learn (with MHG)
  9. Perform Transmission Adaptive Values Learn. Transmission Adaptive Values Learn 
scientia non olet · About LEMON Manuals