Engine Support Fixture (LF4)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Support Fixture (LF4)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Front Compartment Front Sight Shield Replacement (Sedan)Front Compartment Front Sight Shield Replacement (Coupe)Front Compartment Front Sight Shield Replacement (ATS-V) . Front End Sheet Metal Diagonal Brace Replacement - Left Side (ATS-V)Front End Sheet Metal Diagonal Brace Replacement - Left Side Front End Sheet Metal Diagonal Brace Replacement - Right Side (ATS-V)Front End Sheet Metal Diagonal Brace Replacement - Right Side Radiator Surge Tank Replacement (LF4 LGX) . Air Cleaner Outlet Rear Duct Replacement (LF4) . Air Cleaner Outlet Duct Replacement (LF4) . Special Tools EN-36857 Engine Lift Bracket EN-46114 Engine Lift Bracket J-28467-5A Engine Support Beam Adapters J-28467-33 Strut Tower To Support Beam Adapters J-28467-B Main Support Beam J-36462-1A Radiator Tube Shelf Assembly EN-28467-1A Cross Bracket EN-28467-4A Front Support Assembly J-28467-6A Bracket Assembly EN-28467-8A Hook Assembly EN-28467-34 Lift Hook Wing Nut and Washer For equivalent regional tools. Refer to Special Tools (LF4)
1	EN-36857 Engine Lift Bracket (Qty:2) Procedure CAUTION: Refer to Fastener Caution . Use a grade 10.9 bolt to install a EN-36857 bracket to the right and left cylinder head in the location shown. Tighten the bolt to 65 N.m (48 lb ft).
2	J-28467-33 Strut Tower To Support Beam Adapters (Qty:6) Procedure Thread the strut tower adapters to the strut towers.
3	J-28467-5A Engine Support Beam Adapters (Qty:2) Procedure Place the engine support beam adapters on the strut towers and secure using wing nuts.
4	J-28467-B Main Support Beam Procedure Install main support beam through engine support beam adapters and pin in place.
5	J-36462-1A Radiator Tube Shelf Assembly (Qty: 2) Procedure Place radiator shelf tubes on top of main support beam.
6	EN-28467-1A Cross Bracket (Qty: 2) Procedure Loosely install cross bracket to retain radiator shelf tube to main support beam. Tighten cross bracket after front support assembly is in place.
7	EN-28467-4A Front Support Assembly (Qty: 2) Procedure Place front support assembly through radiator tube shelf and pin at proper height.
8	J-28467-6A Bracket Assembly (Qty: 2)
9	EN-28467-8A Hook Assembly (Qty: 2)
10	EN-28467-34 Lift Hook Wing Nut and Washer (Qty: 2)