Front End Sheet Metal Diagonal Brace Replacement - Left Side (ATeS-V)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front End Sheet Metal Diagonal Brace - Left Side (ATeS-V)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Intake Manifold Cover Replacement (LF4)Intake Manifold Cover Replacement (LGX) Plenum Front Panel Replacement
1	Front Suspension Upper Mounting Nut CAUTION: Refer to Fastener Caution . Tighten 22 N.m (16 lb ft)
2	Front End Sheet Metal Diagonal Brace Nut Tighten 22 N.m (16 lb ft)
3	Front End Sheet Metal Diagonal Brace Bolt Tighten 22 N.m (16 lb ft)
4	Front End Sheet Metal Diagonal Brace