Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Front Brake Hose - Install
- Brake Hose Fitting Gasket @ Front Brake Hos - Install
- Brake Hose Fitting Bolt - Install and tighten 40 N.m (30 lb ft)
- Bolt - Install and tighten 10 N.m (89 lb in)
- Wheel Speed Sensor Harness Clip @ Brake Hose - Install
- Brake Hose Retainer - Install
- Brake Pipe Fitting - Install and tighten 18 N.m (13 lb ft)
- Bleed the brake system. Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure)
- Front Wheelhouse Splash Shield Replacement (AWD)Front Wheelhouse Splash Shield Replacement (RWD) - Install
- Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series October 4th 2015 and Earlier)Tire and Wheel Removal and Installation (V-Series October 5th 2015 and Later) - Install
NOTE:
Install new brake hose fitting gaskets.
CAUTION: