Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Using the mechanics wire, guide the oil pump flow control solenoid valve harness (3) into place, then remove the wire.
- Oil Pump Flow Control Solenoid Valve Harness Bolt -Install and tighten 15 N.m (11 lb ft)
- Engine Wiring Harness -Connect
- Oil Pump Flow Control Solenoid Valve Harness @ Crankshaft Oil Deflector -Install
- Oil Pump Flow Control Solenoid Valve Harness @ Retainer -Install
- Oil Pump Flow Control Solenoid Valve Harness @ Oil Pump Flow Control Solenoid Valve -Connect
- Lower Oil Pan Replacement (AWD)Lower Oil Pan Replacement (RWD) -Install
- Front Compartment Lower Noise Shield Replacement (RWD)Front Compartment Lower Noise Shield Replacement (AWD) -Install
CAUTION:
Refer to Fastener Caution .