Front Cover Installation
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Front Cover Installation
| Callout | Component Name |
|---|---|
| Preliminary Procedure If the oil pan was removed it is easier to install after the front cover installation.Refer to:Oil Pan Installation . Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant |
|
| 1 | Engine Front Cover Locating Pin |
| 2 | Engine Front Cover Procedure
Special Tools EN-46109 Guide Pins For equivalent regional tools, refer to Special Tools . |
| 3 | Engine Front Cover Bolt
CAUTION:
Refer to Fastener Caution . Tighten in sequence 10 N.m (89 lb in) |
| 4 | Engine Front Cover Bolt Tighten in sequence 15 N.m (11 lb ft) |
| 5 | Engine Front Cover Bolt
NOTE:
Part of engine mount on Front Wheel Drive version. Tighten in sequence 60 N.m (44 lb ft |
| 6 | Engine Front Cover Bolt
NOTE:
Part of engine mount on Front Wheel Drive version. Tighten in sequence 60 N.m (44 lb ft |
| 7 | Oil Pump Flow Control ValveElectrical Connector
NOTE:
The retaining clips attached to the oil pump flow control solenoid wire are used for initial production only and should be removed and discarded. |