LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 396 (Automatic Transmission Cooling System) >> Repair Instructions >> Transmission Fluid Cooler Inlet Pipe Replacement (M7U, M7W without V08) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove Front Bumper Fascia - Front Bumper Fascia Replacement
    2. Fig 1: Transmission Fluid Cooler Pipe Nut
    GM4355528Courtesy of GENERAL MOTORS COMPANY
  2. Remove Transmission Fluid Cooler Pipe Nut (2)
  3. Remove Transmission Fluid Cooler Inlet Pipe (1) @Transmission
    4. Fig 2: Transmission Fluid Cooler Pipe Fitting Seal
    GM4233917Courtesy of GENERAL MOTORS COMPANY
  4. Remove Transmission Fluid Cooler Pipe Fitting Seal (1) and DISCARD
    5. Fig 3: Transmission Fluid Cooler Pipe Clip
    GM4355562Courtesy of GENERAL MOTORS COMPANY
  5. Remove Transmission Fluid Cooler Pipe Clip (1)
    6. Fig 4: Transmission Fluid Cooler Inlet Pipe And Transmission Fluid Auxiliary Cooler Inlet Pipe
    GM4355571Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect Transmission Fluid Cooler Inlet Pipe (1) @Transmission Fluid Auxiliary Cooler Inlet Pipe (2) - Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection 
  7. Cap the openings to prevent contamination.
  8. Remove Transmission Fluid Cooler Inlet Pipe
  9. Transfer components as necessary.
scientia non olet · About LEMON Manuals