Front Bumper Fascia Replacement

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Bumper Fascia

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Front Wheelhouse Liner Replacement Front Wheel Opening Molding Replacement Hood Front Edge Weatherstrip Replacement
1	Front Bumper Fascia Bolt (Qty: 11) CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Front Bumper Fascia Procedure Carefully push a small nylon wedge between the fascia and the front fascia guide.Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide. Disconnect the electrical connectors. Transfer components as necessary. Reconnect the electrical connectors. Test and confirm fog lamp operation if required.

Callout

Component Name

Preliminary Procedures

Front Wheelhouse Liner Replacement
Front Wheel Opening Molding Replacement
Hood Front Edge Weatherstrip Replacement

Front Bumper Fascia Bolt (Qty: 11)

CAUTION:

Refer to Fastener Caution .

Tighten
2.5 N.m (22 lb in)

Front Bumper Fascia

Procedure

Carefully push a small nylon wedge between the fascia and the front fascia guide.Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide.
Disconnect the electrical connectors.
Transfer components as necessary.
Reconnect the electrical connectors.
Test and confirm fog lamp operation if required.