LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 389 (Engine Controls And Fuel - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Engine Wiring Harness Oxygen Sensor Lead Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Wiring Harness Oxygen Sensor Lead Bracket And Bolt
    GM4373918Courtesy of GENERAL MOTORS COMPANY
  1. Install Engine Wiring Harness Oxygen Sensor Lead Bracket (2)
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install and tighten Engine Wiring Harness Oxygen Sensor Lead Clip Bolt (1) to 9 N.m (80 lb in)
    3. Fig 2: Retainers
    GM4373897Courtesy of GENERAL MOTORS COMPANY
  3. Install Retainers (1) (Qty: 2)
  4. Install Front Bumper Fascia. Refer to Front Bumper Fascia Replacement
scientia non olet · About LEMON Manuals