Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Actuator Solenoid Valve Solenoid - Bank 1 (Right Side) Intake

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove Camshaft Housing Cover Insulator - Right Side. Refer to Camshaft Housing Cover Insulator Replacement - Right Side
1	Camshaft Position Actuator Solenoid Valve Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Actuator Solenoid Valve
3	O-Ring NOTE: Install a NEW O-ring seal. NOTE: Lubricate the NEW O-ring seals with clean engine oil.
4	Camshaft Position Actuator Solenoid Valve Seal NOTE: Always install the camshaft position actuator solenoid valve seal supplied with the NEW camshaft position actuator solenoid valve. If reinstalling the valve, inspect the camshaft position actuator solenoid valve seal and replace as necessary.