Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Install both rear seat supports (4) in the vehicle to set the cross-car width.
- Install Rear Seat Cushion Bracket (3)
- Install Rear Seat Cushion Bracket Washers (2)
- Install and tighten Rear Seat Cushion Bracket Fasteners (1) (Qty: 2) to 2.5 N.m (22 lb in)
- Install Rear Seat Frame Stanchion (2)
- Install and tighten Rear Seat Frame Nuts (1) (Qty: 4) to 50 N.m (37 lb ft)
- Install Rear Seat Back Panel (3)
- Install and tighten Rear Seat Frame Nuts (1) (Qty: 4) to 50 N.m (37 lb ft)
- Install and tighten Rear Seat Back Panel Bolt (2) to 75 N.m (55 lb ft)
- Install Rear Seat Cushion Frame (3)
- Install and tighten Rear Seat Cushion Frame Bolt-Front (2) (Qty: 2) to 32.5 N.m (24 lb ft)
- Install and tighten Rear Seat Cushion Frame Bolt-Upper (1) (Qty: 2) to 32.5 N.m (24 lb ft)
- Install Rear Seat Inner Recliner Cable (1). Refer to Rear Seat Inner Recliner Cable Replacement (Upper) Rear Seat Inner Recliner Cable Replacement (Lower)
- Install Rear Seat Back Cushion Cover and Pad (2). Refer to Rear Seat Back Cushion Cover and Pad Replacement (40%)
- Install Rear Seat Cushion Cover and Pad (3). Refer to Rear Seat Cushion Cover and Pad Replacement (40%)
CAUTION:
Refer to Fastener Caution .