Removal Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refer to Brake Dust Warning .
WARNING:
Refer to Brake Fluid Irritant Warning .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (ATS)Lifting and Jacking the Vehicle (ATS-V)
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series)
- Remove Front Wheelhouse Splash Shield. Refer to Front Wheelhouse Splash Shield Replacement (Rear Wheel Drive)Front Wheelhouse Splash Shield Replacement (All Wheel Drive)
- Disconnect Brake Pipe Fitting (1)
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
- Remove Brake Hose Retainer (1).
- Release Wheel Speed Sensor Harness Clip (1) (Qty: 2) @ Brake Hose.
- Remove Bolt (1)
- Remove Brake Hose Fitting Bolt (1)
- Remove and DISCARD Brake Hose Fitting Gaskets (1) (Qty: 2) @ Front Brake Hose (2)
- Remove Front Brake Hose
NOTE:
Do not reuse the brake hose fitting gaskets.