LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Hydraulic Brake System) >> Repair Instructions >> Front Brake Hose Replacement (J55) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

WARNING:

Refer to Brake Fluid Irritant Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (ATS)Lifting and Jacking the Vehicle (ATS-V) .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series) .
  3. Remove the front wheelhouse splash shield. Refer to Front Wheelhouse Splash Shield Replacement (Rear Wheel Drive)Front Wheelhouse Splash Shield Replacement (All Wheel Drive) .
    4. Fig 1: Brake Pipe Fitting
    GM2830441Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the brake pipe fitting (1) from the brake hose.
  5. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
    6. Fig 2: Brake Hose Retaining Clip
    GM2830444Courtesy of GENERAL MOTORS COMPANY
  6. Remove the brake hose retaining clip (1).
    7. Fig 3: Wheel Speed Sensor Harness Clips
    GM2830454Courtesy of GENERAL MOTORS COMPANY
  7. Release the brake hose from the wheel speed sensor harness clips (1).
    8. Fig 4: Brake Hose Bracket Bolt
    GM2830457Courtesy of GENERAL MOTORS COMPANY
  8. Remove the brake hose bracket bolt (1).
    9. Fig 5: Brake Hose Fitting Bolt
    GM2827510Courtesy of GENERAL MOTORS COMPANY
  9. Remove the brake hose fitting bolt (1).
    10. NOTE:

    Do not reuse the brake hose fitting gaskets.

  10. Remove and discard the brake hose fitting gaskets (2) from the brake hose fitting (3).
  11. Remove the brake hose.
scientia non olet · About LEMON Manuals