Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- On a clean flat surface, map wiring harness routing using the old trim panel as a template.
- Once the harness has been mapped on the trim panel, ensure all the electrical connectors are made. Glue the harness to the new trim panel.
- With the aid of an assistant, position the headliner trim panel assembly (2) into the vehicle through the front windshield.
- Install the two screws (1) to the front portion of the headliner at the roof console backing plate.
- Connect the electrical connectors to the headliner trim panel assembly (1) and secure.
- Install the rear window panel trim (2). Refer to Rear Window Panel Trim Replacement (Sedan) .
- Install the center pillar upper trim panel assembly (1). Refer to Center Pillar Upper Trim Panel Replacement (Sedan) .
- Install the windshield garnish molding assembly (1). Refer to Windshield Garnish Molding Replacement .
- Install the roof console assembly (1). Refer to Roof Console Replacement .
- Install the roof rail rear seat position reading and courtesy lamp (1). Refer to Roof Rail Rear Seat Position Reading and Courtesy Lamp Replacement .
- Install the roof rail assist handle assembly (2). Refer to Roof Rail Assist Handle Replacement (Sedan) .
- Install the sunshade support assembly (2). Refer to Sunshade Support Replacement .
- Install the sunshade assembly (3). Refer to Sunshade Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling .