Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install Rear Suspension Bracket (3)
- Install the two rear suspension front bracket bolts (1) and tighten to 58 N.m (43 lb ft)
- Install a NEW Rear Suspension Cradle Rear Mounting Bolt (2)Rear Suspension Cradle Replacement
- Reposition the hoist lift pad (2) back underneath the vehicle.
- Using the adjustable 2 ton tripod jack stand jack stand (1) and the block of wood, slowly lower the vehicle back on the hoist pad (2).
- Remove the adjustable 2 ton tripod jack stand jack stand (2) and the block of wood (1) from underneath the vehicle.
- Install Underbody Rear Air Deflector Underbody Rear Air Deflector Replacement - Left Side , or Underbody Rear Air Deflector Replacement - Right Side
- Remove the jack stand (1) supporting the rear drive axle.
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.