Clutch Housing Shift Shaft Bearing and Input Shaft Seal Removal

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Input Shaft Seal & Shift Shaft Bearing Assembly

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Shift Shaft Bearing Assembly Procedure Install the DT 49216 bushing remover into the bearing. Install the J 23907-1 slide hammer into the remover. Remove the bearing. Special Tools DT 49216 Bushing Remover J 23907-1 Slide Hammer For equivalent regional tools, refer to Special Tools .
2	Input Shaft Seal

Callout

Component Name

Shift Shaft Bearing Assembly

Procedure

Install the DT 49216 bushing remover into the bearing.
Install the J 23907-1 slide hammer into the remover.
Remove the bearing.

Special Tools
DT 49216 Bushing Remover
J 23907-1 Slide Hammer
For equivalent regional tools, refer to Special Tools .

Input Shaft Seal