Front End Sheet Metal Diagonal Brace Replacement - Left Side

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front End Sheet Metal Diagonal Brace & Mounting Components - Left Side

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the plenum front panel. Refer to Plenum Front Panel Replacement . Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement , Intake Manifold Cover Replacement (LGX) If equipped with LFX, reposition the wire harness in front of the brace.
1	Front End Sheet Metal Diagonal Brace Nut CAUTION: Refer to Fastener Caution . Tighten 22 N.m (16 lb ft)
2	Front End Sheet Metal Diagonal Brace Bolt - Rear Tighten 9 N.m (80 lb in)
3	Front End Sheet Metal Diagonal Brace Bolt - Front (Qty: 2) Tighten 22 N.m (16 lb ft)
4	Front End Sheet Metal Diagonal Brace