LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Solenoid Cable Replacement (LGX) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection 
  2. Remove Air Inlet Grille Panel. Refer to Air Inlet Grille Panel Replacement (Sedan)Air Inlet Grille Panel Replacement (Coupe)
  3. Remove Starter Heat Shield. Refer to Starter Shield Replacement (LGX) 
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (ATS)
    5. Fig 1: Starter Solenoid Cable
    GM4082033Courtesy of GENERAL MOTORS COMPANY
  5. Remove Starter Solenoid Cable Nut (1)
  6. Remove Fastener (3)
  7. Remove Starter Solenoid Cable (2)
  8. Lower the vehicle.
    9. Fig 2: Retainers
    GM4083263Courtesy of GENERAL MOTORS COMPANY
  9. Release the retainers. (1)
    10. Fig 3: Power Distributor Fuse Block Cover
    GM4083264Courtesy of GENERAL MOTORS COMPANY
  10. Remove Power Distributor Fuse Block Cover (1)
  11. Remove Battery Fuse Block Battery Positive Cable Nut (2)
  12. Remove Battery Positive Cable (3)
  13. Remove Starter Solenoid Cable (4)
    14. Fig 4: Starter Solenoid Cable Retainers
    GM4083266Courtesy of GENERAL MOTORS COMPANY
  14. Release the retainers (1).
  15. Remove Starter Solenoid Cable (2).
scientia non olet · About LEMON Manuals