Removal Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove Intake Manifold Cover (3) - Intake Manifold Cover Replacement (LF4)
- Remove Fuel Pipe Shield (1) - Fuel Pipe Shield Replacement (LF4)
- Remove Hood Strut - Right Side (1) - Hood Strut Replacement (ATS-V)
- Disconnect Heater Inlet Hose (1) @Engine Coolant Thermostat Housing - Heater Inlet Hose Replacement (LF4)
- Disconnect Heater Outlet Hose (1) @Engine Coolant Thermostat Housing - Heater Outlet Hose Replacement (LF4)
- Disconnect Engine Coolant Temperature Sensor Electrical Connector (1)
- Disconnect the engine electrical wiring harness (2) from the back of the engine and relocate to improve access.
- Disconnect Evaporative Emission Canister Purge Tube (1) @Evaporative Emission Canister Purge Pipe and position aside - Evaporative Emission Canister Purge Tube Replacement (LF4)
- Disconnect Fuel Feed Pipe (1) @Engine - Fuel Feed Pipe Replacement (Fuel Tank To Engine LF4)Fuel Feed Pipe Replacement (LF4 at Engine)
- Remove Radiator Outlet Pipe (3) - Radiator Outlet Pipe Replacement (LF4)
- Remove Engine Coolant Thermostat Housing Bolt (1)
- Remove Engine Coolant Thermostat Housing (2)
- Remove Engine Coolant Thermostat Housing Gasket (3) and DISCARD