LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Engine Controls And Fuel - 3.6L (LGX LF4) - Repair Instructions) >> Repair Instructions >> Fuel Tank Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the following components if fuel tank replacement was necessary:
    1. Fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement .
  2. Fig 1: Fuel Tank
    GM2815733Courtesy of GENERAL MOTORS COMPANY
  3. Use a suitable jack and install the fuel tank (1).
  4. Fig 2: Fuel Tank Straps And Bolts
    GM2815736Courtesy of GENERAL MOTORS COMPANY
  5. Install the fuel tank straps (2).
  6. CAUTION:

    Refer to Fastener Caution .

  7. Install the fuel tank strap bolts (1) and tighten to 20 N.m (15 lb ft).
  8. Connect the fuel tank electrical connector.
  9. Fig 3: Evaporative Emission And Fuel Pipes
    GM2815749Courtesy of GENERAL MOTORS COMPANY
  10. Install the filler pipe and tighten the hose clamps (1).
  11. Connect the evaporative emission and fuel pipes (2). Refer to Plastic Collar Quick Connect Fitting Service .
  12. Install the two piece propeller shaft. Refer to Two-Piece Propeller Shaft Replacement (LTG, LGX, LCV)Two-Piece Propeller Shaft Replacement (LF4) .
  13. Install the left and right side rear air deflectors. Refer to Underbody Rear Air Deflector Replacement - Left Side , and Underbody Rear Air Deflector Replacement - Right Side .
  14. Refill the fuel tank.
  15. Inspect for fuel leaks.