LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Engine Controls And Fuel - 3.6L (LGX LF4) - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust (LF4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Position Sensor - Bank 1 (Right Side) Exhaust (LF4)
    GM3533401Courtesy of GENERAL MOTORS COMPANY
  1. Install the CMP sensor (2) into to the engine front cover.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the CMP sensor to engine front cover retaining bolt (1) and tighten to 10 N.m (89 lb in).
  3. Connect the CMP sensor electrical connector.
  4. Connect the radiator inlet hose. Refer to Radiator Inlet Hose Replacement (LF4) .
  5. Install Air Cleaner Outlet Duct. Refer to Air Cleaner Outlet Duct Replacement (LF4) 
  6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (LF4) .
scientia non olet · About LEMON Manuals