Intake Manifold Replacement (LGX)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Intake Manifold Replacement (LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Air Cleaner Outlet Duct Replacement (LGX) Detach positive crankcase ventilation tube retainer from intake manifold. Disconnect and reposition the EVAP purge tube. Plastic Collar Quick Connect Fitting Service Disconnect the electrical connectors. Fuel Pipe Shield Replacement (LGX)
1	Intake Manifold Bolt (Qty: 8) CAUTION: Refer to Fastener Caution . Tighten in sequence 25 N.m (18 lb ft)
2	Intake Manifold Procedure Transfer components as necessary. Intake Manifold Disassemble (LGX) , and Intake Manifold Assemble (LGX) NOTE: Install NEW gaskets.

Callout

Component Name

Preliminary Procedures

Air Cleaner Outlet Duct Replacement (LGX)
Detach positive crankcase ventilation tube retainer from intake manifold.
Disconnect and reposition the EVAP purge tube. Plastic Collar Quick Connect Fitting Service
Disconnect the electrical connectors.
Fuel Pipe Shield Replacement (LGX)

Intake Manifold Bolt (Qty: 8)

CAUTION:

Refer to Fastener Caution .

Tighten in sequence
25 N.m (18 lb ft)

Intake Manifold
Procedure
Transfer components as necessary. Intake Manifold Disassemble (LGX) , and Intake Manifold Assemble (LGX)

NOTE:

Install NEW gaskets.