LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (Engine Mechanical - 3.6L (LGX LF4) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Cover Replacement - Right Side (LGX) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove Camshaft Housing Cover Insulator.Camshaft Housing Cover Insulator Replacement - Right Side 
  2. Disconnect Positive Crankcase Ventilation Tube@Camshaft Cover
  3. Remove Ignition Coil. Ignition Coil Replacement - Bank 1 (LGX)
  4. Remove Camshaft Position Actuator Solenoid Valve Solenoid - Bank 1 (Right Side) Exhaust. Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust (LGX)
  5. Remove Camshaft Position Actuator Solenoid Valve Solenoid - Bank 1 (Right Side) Intake. Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake (LGX)
  6. Disconnect and remove the engine harness from the camshaft cover.
  7. Fig 1: Fuel Feed Pipe -- At Engine (LGX)
    GM4163340Courtesy of GENERAL MOTORS COMPANY
  8. Remove the fuel feed pipe bracket bolt (1) and reposition the fuel feed lines. Fuel Feed Pipe Replacement (Fuel Tank To Engine LGX)Fuel Feed Pipe Replacement (LGX at Engine)
  9. Fig 2: Camshaft Cover, Bolt, Seal
    GM4140421Courtesy of GENERAL MOTORS COMPANY
  10. Remove Camshaft Cover Bolt (1)
  11. Remove Camshaft Cover (2)
  12. Remove Camshaft Cover Seal (3) and DISCARD
  13. Disassemble the camshaft cover as needed. Camshaft Cover Disassemble (LGX) .
  14. Clean the mating surfaces of the cylinder head and the camshaft cover. Camshaft Cover Cleaning and Inspection (LGX)