Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the control valve body cover wiring connector hole seal.
- Install the control valve body cover gasket to the control valve body cover.
- Install the control valve body cover.
- Lower the transmission and remove the transmission jack.
- Install the 12 control valve body cover bolts (1) M6 x 30 and tighten the bolts in sequence to 12 N.m (106 lb in).
- Install the 2 control valve body cover studs (2) M6 x 30 and tighten the studs in sequence to 12 N.m (106 lb in).
- Connect the control valve body TCM electrical connector (1).
- Install the lower nuts to the left transmission mount. Refer to Transmission Mount Replacement - Left Side .
- Install the front transmission mount. Refer to Transmission Front Mount Replacement .
- Lower the vehicle.
- Install the oil cooler inlet and outlet hoses to the retainer on the control valve body cover.
- Install the battery tray. Refer to Battery Tray Replacement .
- Fill the transmission. Refer to Transmission Fluid Drain and Fill .
- Check for leaks.
NOTE:
The holes in the control valve body cover wiring connector hole seal must face toward the control solenoid valve assembly. If the holes face toward the valve body cover, there is a potential for a leak around the seal.
CAUTION:
Refer to Fastener Caution .
NOTE:
Install all control valve body cover bolts and studs by hand then torque all bolts and studs in sequence.