LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Acadia SL, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Latch Cable Replacement - Outboard

Rear Seat Latch Cable Replacement - Outboard

Fig 1: Identifying Rear Seat Latch Cable - Outboard
GM1863135Courtesy of GENERAL MOTORS CORP.
Rear Seat Latch Cable Replacement - Outboard

Callout Component Name
Preliminary Procedures 
Remove the rear seat back cushion cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement (with 60 Percent Seat) , Rear Seat Back Cushion Cover and Pad Replacement (with 40 Percent Seat without Armrest) , Rear Seat Back Cushion Cover and Pad Replacement (with 40 Percent Seat with Armrest) .
1 Rear Seat Back Cushion Panel

Procedure

  1. Note the routing for installation, the inboard cable should be routed over the outboard cable.
  2. Cut off the rosebud retainer to remove and always install a new retainer for installation.
  3. Disconnect the seat latch cable.
scientia non olet · About LEMON Manuals