LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Acadia SL, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Driver or Passenger Seat Adjuster Track Replacement

Driver or Passenger Seat Adjuster Track Replacement

Fig 1: Identifying Seat Adjuster Track
GM1837698Courtesy of GENERAL MOTORS CORP.
Driver or Passenger Seat Adjuster Track Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the front bucket seat. Refer to Bucket Seat Replacement .
  2. Remove the front seat front finish panel. Refer to Front Seat Front Finish Panel Replacement .
  3. Remove the front seat cushion front finish panel bracket. Refer to Front Seat Cushion Front Finish Panel Bracket Replacement .
  4. Remove the driver or passenger seat adjuster shield. Refer to Driver or Passenger Seat Adjuster Shield Replacement .
  5. Remove the driver or passenger seat adjuster handle, if equipped. Refer to Front Seat Front Finish Panel Replacement .
  6. Remove the front seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .
1 Front Seat Adjuster Track Assembly Bolt (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
12 N.m (9 lb ft)
2 Front Seat Adjuster Track Assembly

Procedure

  1. Disconnect any electrical connectors, if equipped.
  2. If replacing with a new front seat adjuster track assembly, transfer components as necessary.
  3. For manual track synchronization, refer to Front Seat Track Synchronization .
scientia non olet · About LEMON Manuals