Rocker Panel Rear Molding Replacement (Enclave)

Fig 1: Identifying Rocker Panel Rear Molding (Enclave)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open the rear side door on the side the molding is to be replaced. Remove the outer lower screw from the rocker panel molding extension. Refer to Rocker Panel Extension Molding Replacement . Disengage the rear most retainer clip from the front and rear side door lower weatherstrip that attaches to the rocker panel rear molding.
1	Rear Wheelhouse Liner Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 1.5 N.m (13 lb in)
2	Retainer (Qty: 3)
3	Rocker Panel Rear Molding Procedure Detach the rear rocker panel molding from the front rocker panel molding.