Valve Lifter Removal - Left Side

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying SHLAs In Cylinder Head

Courtesy of GENERAL MOTORS CORP.

NOTE:

Do not stroke/cycle the stationary hydraulic lash adjuster plunger without oil in the lower pressure chamber.
Do not allow the stationary hydraulic lash adjuster to tip over, plunger down, after the oil fill.

Remove the valve lifters (SHLAs) from the cylinder head. If the lifters are to be reused, keep in order so they can be reinstalled in the same position.