Connecting Rod Crankshaft Bearing End

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Connecting Rod Crankshaft Bearing Bore

Courtesy of GENERAL MOTORS CORP.

NOTE: Measurements of all components should be taken with the components at normal room temperature.

Using an inside micrometer, measure the connecting rod crankshaft bearing bore.
Compare the bore measurements with the Engine Mechanical Specifications (LF1) or Engine Mechanical Specifications (LAU or LBW) .
Replace the connecting rod if the bore is out of specifications. DO NOT recondition the connecting rod.