LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Engine Mechanical - 2.8L Or 3.0L - Repair Instructions - On Vehicle (2 Of 2)) >> Cylinder Head Replacement - Right Side (LAU) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft cover. Refer to Camshaft Cover Replacement - Right Side (LAU) .
  2. Remove the right bank secondary timing chain. Refer to Secondary Camshaft Intermediate Drive Chain Replacement - Right Side .
  3. Remove the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (LAU) .
  4. Remove the right engine lift bracket at the rear of the right cylinder head.
    5. Fig 1: View Of Right Cylinder Head
    GM902818Courtesy of GENERAL MOTORS CORP.
  5. Remove the right cylinder head bolts.
  6. Remove the right cylinder head.
    7. Fig 2: View Of Cylinder Head Gasket
    GM902817Courtesy of GENERAL MOTORS CORP.
  7. Remove and discard the cylinder head gasket.
  8. Clean and inspect the cylinder head and the engine block sealing surfaces. Refer to Cylinder Head Cleaning and Inspection and Engine Block Cleaning and Inspection .
  9. Disassemble the cylinder head if needed. Refer to Cylinder Head Disassemble (LAU or LBW) .
scientia non olet · About LEMON Manuals