LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Acadia Denali, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Front End Upper Tie Bar Support Replacement

Front End Upper Tie Bar Support Replacement

Fig 1: Identifying Front End Upper Tie Bar Support
GM1938548Courtesy of GENERAL MOTORS CORP.
Front End Upper Tie Bar Support Replacement

Callout Component Name

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Reposition the inflatable restraint front end sensor. Refer to Inflatable Restraint Front End Sensor Replacement .
  3. Reposition the engine control module. Refer to Engine Control Module Replacement .
  4. Reposition the power brake booster auxiliary pump. Refer to Power Brake Booster Auxiliary Pump Replacement .
  5. Reposition the suction hose. Refer to Suction Hose Replacement .
  6. Reposition the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement .
  7. Reposition the radiator. Refer to Radiator Replacement (Acadia and Traverse) , Radiator Replacement (Enclave) .
  8. Remove the front bumper impact bar. Refer to Front Bumper Impact Bar Replacement .
  9. Remove the headlamps. Refer to Headlamp Replacement (Acadia) , Headlamp Replacement (Traverse with TVP) , Headlamp Replacement (Enclave) .
  10. Remove the hood primary and secondary latch. Refer to Hood Primary and Secondary Latch Replacement .
1 Front End Upper Tie Bar Support Bolt (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Front End Upper Tie Bar Support Lower Bolt (Qty: 2)
Tighten 
9 N.m (80 lb in)
3 Front End Upper Tie Bar Support

Procedure

  1. Disconnect the electrical connectors/harnesses as needed.
  2. Transfer any parts as needed.
scientia non olet · About LEMON Manuals