Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
Remove the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece .
Pry out the rear output shaft seal, using a flat-tipped screwdriver.

Fig 1: Removing Rear Output Shaft Seal
Courtesy of GENERAL MOTORS CORP.
Inspect the rear output shaft bushing for scoring or wear.
Remove the rear output shaft bushing if required, using the J 45380 . See Special Tools .
- Install the finger section of the J 45380 into the front of the bushing. See Special Tools .
  
  Fig 2: Removing Rear Output Shaft Bushing
  Courtesy of GENERAL MOTORS CORP.
- Install the tube and forcing screw to the finger section. Ensure the forcing screw is backed out.
- Using a wrench on the forcing screw, remove the rear output shaft bushing.