LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Condenser Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Radiator Support Bolts
    GM1987767Courtesy of GENERAL MOTORS CORP.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. Remove the fascia.
  3. Remove radiator support bolts (1). Access the bolts from the rear of the upper radiator support. Refer to Radiator Support Replacement .
  4. Remove radiator support bracket bolts (1).
    5. Fig 2: View Of Discharge Hose At Condenser
    GM363062Courtesy of GENERAL MOTORS CORP.
  5. Remove the compressor discharge hose assembly bolt from the condenser.
  6. Disconnect the compressor discharge hose assembly from the condenser.
    7. Fig 3: Evaporator Tube To Condenser
    GM363033Courtesy of GENERAL MOTORS CORP.
  7. Remove the evaporator tube nut from the condenser.
  8. Disconnect the evaporator tube from the condenser.
  9. Remove the insulator retainer bolts and the upper insulator retainers.
  10. Remove the condenser from the vehicle.
scientia non olet · About LEMON Manuals