Stabilizer Shaft Link Replacement (2500/3500)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Stabilizer Shaft Link (2500/3500)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the engine shield, if equipped. Refer to Engine Shield Replacement . Remove the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement (1500) or Stabilizer Shaft Link Replacement (2500/3500) . Remove the stabilizer shaft insulator. Refer to Stabilizer Shaft Insulator Replacement (1500) or Stabilizer Shaft Insulator Replacement (2500, 3500) .
1	Stabilizer Shaft Link Retaining Nut NOTE: Refer to Fastener Notice . Procedure Remove all traces of the original adhesive patch. Apply Threadlocker GM P/N 12345382 (Canadian P/N 10953489) BLUE LOCTITE # 242 on the threads of the bolt. Tighten: 23 N.m (17 lb ft)
2	Front Stabilizer Shaft Insulator (Qty: 4)
3	Front Stabilizer Shaft Washer (Qty: 2)
4	Front Stabilizer Shaft Spacer
5	Front Stabilizer Shaft Washer
6	Front Stabilizer Shaft Bolt