Rear Side Door Window Regulator Replacement (Extended Cab, Power)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Window Regulator, Nuts & Bolt

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (YE9) or Rear Side Door Trim Panel Replacement (SLT) . Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
1	Rear Side Door Window Regulator Bolt NOTE: Refer to Fastener Notice . Procedure Place the door window in the up position Tape the window to the door frame to prevent it from moving. Loosen the upper bolts that attach the window regulator to the inner door. Tighten: 9 N.m (80 lb in)
2	Rear Side Door Window Regulator Nuts (Qty: 2) Tighten: 9 N.m (80 lb in)
3	Rear Side Door Window Regulator Procedure Disconnect the electrical connector. Transfer the power window motor to the new regulator. Refer to Rear Side Door Window Regulator Motor Replacement (Crew Cab) or Rear Side Door Window Regulator Motor Replacement (Extended Cab) .