Rear Side Door Trim Panel Replacement (SLT)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Trim Panel (SLT)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove rear door window control switch. Refer to Rear Side Door Window Switch Replacement (Extended Cab) or Rear Side Door Window Switch Replacement (Crew Cab) .
1	Rear Side Door Locking Rod Knob Assembly Procedure Lower the window. Ensure the locking rod is in the unlocked position. Use a flat-bladed tool to disengage detent tab, then remove knob by pulling upward. When re-installing, push the knob down, until the detent tab touches locking rod opening cover. Push the detent tab in to lock knob to locking rod.
2	Rear Side Door Trim Panel Cover
3	Rear Side Door Trim Panel Cover Retainer (Qty: 4)
4	Rear Side Door Inside Handle Bezel Cover
5	Rear Side Door Trim Panel Bolt (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
6	Rear Side Door Trim Panel Assembly
7	Rear Side Door Cable Retainer Tip: Pull upward to disengage.
8	Rear Side Door Trim Panel Retainer (Qty: 10)