Rear Side Door Outside Handle Replacement (Crew Cab)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Outside Handle & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement (YE9) or Rear Side Door Trim Panel Replacement (SLT) . Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
1	Rear Outside Door Handle Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tip: Release the outside handle rod from the lock retainer clip. Release the lock cylinder rod from the door lock. Remove the outside door handle with the rod attached. Tighten: 7 N.m (62 lb in)
2	Rear Side Door Outside Handle Tip: Transfer the handle rod to the new handle.

Callout

Component Name

Preliminary Procedures

Position the door window as needed for service.
Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement (YE9) or Rear Side Door Trim Panel Replacement (SLT) .
Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .

Rear Outside Door Handle Bolt (Qty: 2)

NOTE: Refer to Fastener Notice .

Tip:

Release the outside handle rod from the lock retainer clip.
Release the lock cylinder rod from the door lock.
Remove the outside door handle with the rod attached.

Tighten: 7 N.m (62 lb in)

Rear Side Door Outside Handle
Tip: Transfer the handle rod to the new handle.