Turn Signal Lamps and/or Indicators Always On or Flashing
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Turn Signal Lamps and/or Indicators Always On or Flashing
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 11 | Go to Step 4 |
| 4 | Are all 4 of the turn signals lamps flashing? | Go to Hazard Lamps Always On | Go to Step 5 |
| 5 | Is only one lamp on at all times? | Go to Step 6 | Go to Step 7 |
| 6 | Test for a short to battery positive voltage in the turn signal voltage circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 12 | Go to Step 9 |
| 7 | Disconnect the multifunction turn signal switch. Do the turn signal lamps turn OFF? |
Go to Step 10 | Go to Step 8 |
| 8 | Test for a short to ground in the either turn signal switch signal circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 12 | Go to Step 9 |
| 9 | Replace the body control module (BCM), driver door switch, or passenger door switch as applicable. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 12 | - |
| 10 | Replace the multifunction turn signal switch. Refer to Turn Signal Multifunction Switch Replacement
. Did you complete the replacement? |
Go to Step 12 | - |
| 11 | Replace the instrument panel cluster (IPC). Refer to Instrument Cluster Replacement (without RPO SLT)
or Instrument Cluster Replacement (with RPO SLT)
. Did you complete the repair? |
Go to Step 12 | - |
| 12 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |