Hazard Lamps Inoperative
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Hazard Lamps Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Turn ON the hazard flashers. Does the system operate normally? |
Go to Testing for Electrical Intermittents | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Turn Signal Lamps and/or Indicators Inoperative |
| 4 | With a scan tool, monitor the Hazard Lamp Switch data parameter in the Body Control Module (BCM) data list while pressing the switch several times. Does the scan tool display Active and Inactive? |
Go to Step 8 | Go to Step 5 |
| 5 | Test the hazard switch signal circuit for an open, high resistance or short to voltage. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 6 |
| 6 | Test the ground circuit of the multifunction switch for high resistance or an open. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 7 |
| 7 | Inspect for poor connections at the harness connector of the multifunction switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 8 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 9 | Replace the multifunction switch. Refer to Turn Signal Multifunction Switch Replacement
. Did you complete the replacement? |
Go to Step 11 | - |
| 10 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |