Rear Seat Back Cushion Cover and Pad Replacement (Extended Cab with AM7)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Back Cushion Cover, Pad & Tether Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the rear bench seat. Refer to Rear Seat Replacement (Extended Cab with RPO AM7) or Rear Seat Replacement (Extended Cab with RPO A68) or Rear Seat Replacement (Crew Cab with RPO A68) . Remove the rear seat back recliner cover. Refer to Rear Seat Back Recliner Cover Replacement (Extended Cab with A68) or Rear Seat Back Recliner Cover Replacement (Crew Cab with A68) . Remove the rear seat head restraint. Refer to Rear Seat Head Restraint Replacement . Remove the rear seat head restraint guides. Refer to Rear Seat Head Restraint Guide Replacement .
1	Rear Seat Back Tether Bolt NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb ft)
2	Rear Seat Back Cushion Cover Procedure Disconnect the j-channel from the seat back cushion frame. Remove the seat back cushion cover and pad as an assembly from the frame. Remove the seat back cushion cover from the pad.
3	Rear Seat Back Cushion Pad