LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1730 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Low and Reverse Clutch Support Disassemble

Low and Reverse Clutch Support Disassemble

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Low & Reverse Clutch Support Components
    GM5705Courtesy of GENERAL MOTORS CORP.
  1. Remove the low and reverse roller clutch race (675) from the low and reverse clutch support (679). Inspect the race for damage and surface finish.
  2. Remove the two low and reverse roller retainer rings (677) and the low and reverse roller clutch assembly (678). Inspect the roller clutch assembly for damaged rollers and broken springs.
  3. Inspect the low and reverse clutch support (679) for loose cam and cam surface finish. Check the support for cracks and damaged lugs.
    4. Fig 2: Low & Reverse Roller Clutch Assembly & Retainer Ring
    GM5706Courtesy of GENERAL MOTORS CORP.
  4. Clean and install the low and reverse roller clutch assembly (678) into the low and reverse clutch support (679). Install the low and reverse retainer ring (677).
scientia non olet · About LEMON Manuals