Fluid Pump Rotor and Slide Measurement

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Oil Pump Rotor & Slide

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Measure the rotor and slide thickness for surface wear. The rotor and slide measurements must both fall into the same thickness range. If the rotor and slide measurements do not fall into the same thickness range, or are outside of all the ranges, the oil pump must be replaced as an assembly.

Refer to Fluid Pump Rotor and Slide Measurement .
Measure the oil pump rotor (212) thickness.
Measure the oil pump slide (203) thickness.