LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1667 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Valve Lifter Replacement (With out AFM) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Valve Lifter Guides, Cylinder Head & Bolts
    GM1403318Courtesy of GENERAL MOTORS CORP.
  1. Remove the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side  or Cylinder Head Replacement - Right Side .
  2. Remove the valve lifter guide bolts (211).
  3. Remove the valve lifter guides (210) with the lifters. Note the installed position of the guides. The notched area of the guides is to align with the locating tab on the engine block.
    4. Fig 2: Valve Lifter Guides & Bolts
    GM1403319Courtesy of GENERAL MOTORS CORP.
  4. Remove the valve lifters (209) from the guide (210).
  5. Organize or mark the components so that they can be installed in the same location from which they were removed, if required.
  6. Clean and inspect the valve lifters, if required. Refer to Valve Lifter and Guide Cleaning and Inspection .
scientia non olet · About LEMON Manuals